Chainsaw pruning method

by:Jiali     2020-06-29
1. When trimming, cut the mouth first and then the upper mouth to prevent the saw from being clipped. 2. When cutting, the following branches should be cut first. Heavy or large branches are cut in sections. 3. When operating, hold the operating handle with your right hand, naturally hold on the handle with your left hand, and straighten your arms as much as possible. The angle between the machine and the ground cannot exceed 60 degrees, but the angle cannot be too low, otherwise it is not easy to operate. 4. In order to avoid damaging the bark, the machine rebounding or the saw chain being caught, first cut a load-relief cut on the lower side when cutting the thick bark, that is, cut an arc cut with the end of the guide plate. 5. If the diameter of the branches exceeds 10 cm, first perform pre-cutting, make unloading cuts and cut cuts at the required cuts of about 20 to 30 cm, and then cut them here with a branch saw.
Custom message
Contact